Install new compressor- Bolt in the new compressor and connect the electrical connector. Remove compressor – Unbolt the compressor and remove it from the unit. The recovered refrigerant must be stored in an approved tank and not released into the air.Ĭut lines – Cut the refrigerant lines on the compressor and disconnect the electrical connector. Keep in mind that in most cases you are required to be certified to remove or install refrigerant. Remove refrigerant – An air conditioning system is under high pressure at all times so it is important to remove relieve the pressure by removing all of the refrigerants. In addition, you may have breakers in your main breaker panel. The power switch and circuit breakers are usually near the unit. Turn off power- Before doing any work on the system it is critical to remove all power from the unit to prevent serious injury or death. The correct part number and type can be found in the unit or the old compressor. Identify type- There are numerous types of compressors so it is very important to ensure that you have to correct type before performing this job. Basic hand tools such as wrenches, screwdrivers, ratchet, and pliers.The following items will need to be replaced on the compressor: Doing the job yourself can also save you a decent amount of money. ![]() Typically, replacing a compressor should be done by a professional, but you can perform this task at home if you are competent working with your hands. The gas can be cooled by immersing the coil in water or by a fan. A compressor works by compressing refrigerant gas and then sending it to a condenser where the gas is cooled and turned into a liquid. If your air conditioner is having problems and you have narrowed it down to a bad compressor, you can replace it following the steps below.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |